Consumables - Electrical Motor Protection

Electrical motor protection is an important part of management and looking forward will save a lot of hassle and money if done right.


Screw Compressor Services
PCE Services
Screw Compressors

With decades of experience; the right attitude, equipment, expertise and high quality parts, your screw compressor gets the right attention and service, extending your ROI.

Talk To An Expert Today!

Servicing all leading brands.
» Click Here to find out more!

⟵   Go back

Consumables - Fans & Motors

Copeland Three Phase Voltage Monitor
Copeland Three Phase Voltage Monitor
  • Helps protect motors from premature failure and burnouts
  • Phase unbalance: 2-5% adjustable
  • Over / Under voltage protection: 2-10% adjustable
  • Phase loss protection: 25% of nominal
  • Delay on break timer: 2-10 minutes
  • Fault interrogation delay: provides a delay between fault detection and system shut down – helps eliminate unessary shut downs
  • Programmable, 25 fault memory
  • 190-630 VAC, 50 / 60 Hz

Sentronic® Oil Pressure Control
Sentronic® Oil Pressure Control

The Copeland Sentronic® electronic oil pressure safety control uses a pressure sensor and an electronic module to precisely measure oil pump differential pressure. Common sources of leaks (bellows, capillary tubes, and pressure connections) are eliminated when using the Sentronic® oil pressure control. The control has a precise electronic clock for the two minute time-out circuit.

Should oil pressure fall below a 7 to 9 PSI differential, the module will open a normally closed contact, shutting the compressor off. A trip of the oil pressure safety switch is a warning that the system has been without proper lubrication for too long. It will also shut the compressor down if the oil pressure fluctuates between acceptable and low oil pressure and records a history of low oil pressure for 60% or more of a running cycle.


Kriwan INT 69
Kriwan INT 69

The INT69 module is suitable for installation in motor terminal boxes. The module is highly reliable and is in use world-wide. Up to 9 PTC thermistors can be connected in series to the measuring circuit input.

If the temperature in one of the areas monitored exceeds nominal response temperature of the PTC thermistor, thesensor resistance increases and the INT69 control module switches the motor contactor off. The module resets when the temperature drops below the response temperature by approximately 3 K.


Kriwan INT 369R
Kriwan INT 369R

The INT369R is designed to protect against excessive motor winding temperatures by monitoring the resistance of PTC thermistors embedded in the windings.

As the winding temperature approaches the design response temperature of the PTC thermistors, the increase in resistance is sensed by the INT369R module. The out put relay drops out immeadiately and locks out. Reset is achieved by interrupting the supply voltage for at least 5 seconds, provided that the fault condition has been corrected.


About PCE

Power Compressor Exchange (PCE) are professional compressor re-manufacturers and stockists of all world-leading brands of compressors and chillers.

With decades of experience; and the right attitude, equipment, expertise and OEM parts, we manage and maintain your chiller or HVAC/R system to run at peak performance and efficiency! Our aim is to ensure that your compressors keep on running for years to come. ... Read More  »


Make The Call


+2711 624 2713

Fax: +2711 624 2716